Car paint coloring tips

As with other paints, the color of the car paint is based on the color of the sample or sample of the paint. The general method of blending is as follows.

1. First, pay attention to the clean environment of the coloring place, fire safety, and prepare color matching containers, tools and test instruments, such as clean mixing tools, standard color cards or templates, colorimeter, color meter, etc.

2, access to information, based on experience or computer measurement to determine the composition of the main color and color of the color, to prepare for the preparation before the coloring.

3. According to the variety and supply of automotive coatings supplied by the market, select the primary color pigments or color pastes required for the main color coating and coloring.

4. Try the sample first. First, determine how many colors of the multi-color paint are included, and initially determine the weight of the various color paints that they participate in the color matching, as a reference for blending large samples. The method of weight measurement is: the color paints that participate in the color matching are respectively placed in the container, and the gross weight is first weighed. After the coloring is completed, weigh it once again, and the difference between the two weighings can be used to obtain various colors of the color matching. The quality of the paint.

5. In the color matching process, the color paint that participates in the color matching should be slowly and intermittently added with a small amount of paint of other colors based on the color of a certain color paint. And constantly stirring, sampling at any time, check the sample, adjust the look, must be patiently matched, in order to make the matching color meet the requirements.

6, when the color paint, first leave half as a spare, in case of over-heading, you can join in, and then carefully re-distributed.

7. If the sample is a dry sample, the color paint should be waited for after drying and then compared. If time is not allowed, it can be judged by experience whether the dry paint film matches the original sample before drying. If the sample is a wet sample, then the sample paint can be thoroughly mixed, and a drop of water is placed next to the paint being prepared for comparison, and the edges are adjusted until the registration is completed.

8. After the sample is registered, the quantity of the color paint to be blended is initially determined. According to the proportion of the various paints participating in the paint, the sample is matched with the same method.

9, when the color paint, should be on a sunny day or under a standard light source, do not continue to observe the color, let the eyes rest for a while and then look. When comparing paints, each time the paint must be thoroughly stirred up and down, and then sampled and compared, in order to reduce errors.

10. When the color matching paint is used, the base paint used must have the same base material, otherwise the resin will be precipitated, floated and precipitated.